![\"rear](\"https:\/\/www.beady.com\/blog\/wp-content\/uploads\/2019\/02\/Aircraft-rivets-and-camper-body-fabrication-4.jpg\")
<\/a><\/figure>\n\n\n\n<\/a><\/figure>\n\n\n\n<\/a><\/figure>\n\n\n\n<\/a><\/figure>\n\n\n\nthe guilty people of doing this..<\/p>\n\n\n\n The old rear doors were cut up to make fillet panels from the OEM to the new rear, pro style, actually better than pro, we know we have seen the competition at work,<\/p>\n\n\n\n notice Rory helping and Alex trying to ignore the hard work going on nearby<\/p>\n\n\n\n and zoe helping to fit the floor<\/p>\n\n\n\n The rear box outer is finished, Chris and I don’t want to see a rivet gun again, but it is very light and Very strong.<\/p>\n\n\n\n Now to the interior panels, they are aluminium laser cut and bonded with foam and finished with Formica to make it pretty<\/p>\n\n\n\n here are the test panels in CAD , we built these to test the design<\/p>\n\n\n\n 6081 aluminium, Formica and then Polyurethane foam to give rigidity<\/p>\n\n\n\n This is the right hand side cabinets looking from the wall side notice the trays, and the aircraft alloy sliders to save weight, but don’t ask the price<\/p>\n\n\n\n This is the right hand side cabinets looking from the wall side notice the trays, and the aircraft alloy sliders to save weight, but don’t ask the price<\/p>\n\n\n\n Did I say I CAD modelled everything .. here is a small selection of models, even the cutlery was modelled.<\/p>\n\n\n\n I could not find any hinges or catches to work with the thin light weight units I had designed for inside so I had to 3d print my own design.<\/p>\n\n\n\n \nThis is the door catch, the idea comes from Airliner galley furniture\n<\/p>\n\n\n\n The cooker CAD model<\/p>\n\n\n\n Custom cooker to take 2 x Primus omni-fuel stoves it can be lifted out and hung on the side of the truck.<\/p>\n\n\n\n This is a test piece I had done to check my design would bend out of one piece of Stainless steel.<\/p>\n\n\n\n and here’s the finished cooker in the kitchen unit when being test built.<\/p>\n\n\n\n now its time to fit the windows and rear insulation , interior insulation and finally the interior.<\/p>\n\n\n\n<\/a><\/a><\/figure>\n\n\n\n<\/a><\/figure>\n\n\n\n<\/a><\/figure>\n\n\n\n<\/a><\/figure>\n\n\n\n<\/figure>\n\n\n\n<\/figure><\/li><\/ul><\/figure>\n\n\n\n<\/a><\/figure>\n\n\n\n<\/a><\/figure>\n\n\n\n
\n\n\n\n<\/a><\/figure>\n\n\n\n<\/a><\/a><\/figure><\/div>\n\n\n\n<\/a>
catch in door locked position, the little nodules are ground off as needed for L & R operation<\/figcaption><\/figure><\/div>\n\n\n\n<\/a><\/figure>\n\n\n\n<\/a><\/a><\/figure>\n\n\n\n<\/a><\/figure>\n\n\n\n
\n\n\n\n