Terratrip sensor interface for Land Rover OEM speedo

want to use the oem speedo sensor on your land rover with your Terratrip?

Then this £1.00 circuit will do it and still let the OE speedo work

terratrip OEM adapter circuit to replace sensor

           terratrip sensor adapter.pdf

It’s this simple, we fit it just before the 12 way plug, this should work for the later Trips, just make sure the Collector of the transistor goes to the common for the sensors and the emitter goes to the+ of the probe.

terratrip speed snsor coverter to use standard 3 wire type sensors

 

Share your joy of knowledge with the world..

2 thoughts on “Terratrip sensor interface for Land Rover OEM speedo

  1. Miguel Frias

    Hi, I’m installing your sugestion in a Range Rover Classic with a Borg Warner transfer box wich have the same output sensor. My question is about the scheme you’ve draw with the transistor and a resistor. The drawing color codes are the ones for the 10lk Ohm unit or is there any other specification I must follow? Is there any other advise needed to make it work fine? Thanks for your contribution and help. Best regards, Miguel.

    1. Beady

      Hi Miguel,
      sorry I forgot to put a value on the resistor 🙁
      try 10k as per the image,
      its a long time ago since I did this , I cant remember the true value,
      these are all you need to make it work

      bd

Leave a Reply

Your email address will not be published. Required fields are marked *