Discovery 2 Snorkel
Bored over xmas, I decided the winter car should get a snorkel so I can abuse it in deep water 🙂
I used Oval Stainless steel exhaust tube leftover from another job and 3D printed some adapters in Carbon/PetG and the top is in Nylon PA6,
it’s all sealed up and is tucked in tight, and I didn’t even have to take the wing off to fit it.
It’s not exactly what I wanted but will do the job ,need to improve the A-pillar mounts a little
Share your joy of knowledge with the world..
Wondering if you still have the 3D print file for the adapter segment to connect to round hose. Looking to install Southdown D1 snorkel on 2003 D2.
Hi Chad,
I pressume you ,mean the interface between the airbox and the snorkel pipe.
http://www.beady.com/BigFileForBlog/EN_3025.zip
This is an STL and a STP file.
you can use a piece of silicon hose to go between the oval and the round pipe.
it bolts through the inner wing ,use some gasket sealer to seal both sides.
have fun
bd